DENSO developed a new high output density power card and a more efficient cooling structure. Compared with its installation in the previous Prius model, application of this advanced power control unit helps to reduce electric power loss by more than 20%.

The solenoid valve is used to control hydraulic pressure and flow. Various types of solenoid valves are available, including linear, duty and on-off, depending on the controlled elements within the system and also with a view to various hydraulic systems.

The integration of control circuit, motor and pump enables a compact body size that achieves high compatibility to a variety of models. Optimized motor control reduces noise.

Use MOSFET for rectifying and inverting to improve efficiency 
High power generation and brake energy recovery
High life, low resistance carbon brush 

This is a compact, high-performance, low cost in-vehicle hydraulic sensor. With a 
single chip configuration, it is limited to the minimum connection point, and the 
failure rate is reduced. It can be also be used for the detection of AT, CVT hydraulic pressure, and engine oil pressure. 

Double-sided cooling 
Smaller size

* At +60°C with air forced at 1m/s